Great Wall · 1982–1990
Great Wall car vehicle-era reference & parts paths · Carburettor era
Great Wall 1982–1990 — carburettor era. Twin-cam petrols on Weber / SU carbs, mechanically-injected diesels, and the first wave of catalytic-converter petrol UK imports. For UK Great Wall owners that means: Expect points, condensers, contact-breaker distributors, K-Jetronic on the early hot hatches and pneumatic boost on the first turbos.
Expect points, condensers, contact-breaker distributors, K-Jetronic on the early hot hatches and pneumatic boost on the first turbos.
Pre-OBD: faults read by analogue test lamp or factory break-out box, MOT emissions still done at idle only.
- Request OE Great Wall 1982–1990 body panels, doors, tailgates and bumpers; the responding supplier must state source and condition.
- For engines, gearboxes and ECUs, ask for the donor details, test evidence, included components and written supplier terms.
- For service items mentioned in this era of manual, confirm whether the quoted item is OE-removed, remanufactured, new OE or aftermarket.
Great Wall parts-request paths · 1982–1990
These are general component categories for the carburettor era, not a claim that every vehicle uses each system. Confirm engine, drivetrain and model-year applicability before ordering or starting work.
- 1–3hCharging & starting
Alternator replacement
Charge-light on, low cranking voltage or noisy bearing — swap the alternator and re-tension the auxiliary belt.
- 1–3hCharging & starting
Starter motor replacement
Hot-start failure, solenoid click or grinding pinion — drop the starter from above or below the bellhousing.
- 3–6hCooling
Water pump & coolant service
Weeping pump, low coolant or impeller noise — replace pump, refresh OAT/G12 coolant and bleed the system.
- 6h+Engine
Timing belt or chain replacement
Mileage-due belt, stretched chain or tensioner rattle — full kit with idler, tensioner and water pump where co-located.
- 6h+Transmission
Clutch kit & DMF
Slipping clutch, judder on pull-away or dual-mass rattle at idle — gearbox-out clutch kit and release-bearing swap.
- 1–3hBrakes
Brake discs & pads
Lipped discs, juddering under braking or low-pad warning — axle pair of discs plus matching friction kit.
- 6h+Engine
Turbocharger replacement
Boost-leak code, smoke under load or shaft-play — full turbo replacement, oil-feed refresh and intercooler flush.
- 1–3hCooling
Radiator replacement
Pinhole leak, snapped plastic end-tank or coolant in the wrong place — drain, swap and bleed.
Great Wall 1982–1990 · pick a model year
Every year opens the parts finder pre-filled for your Great Wall model year. Confirm technical procedures with a suitably qualified repair professional.
Other Great Wall eras
- Where can I confirm a repair procedure for Great Wall 1982–1990?
- Use the job cards to prepare a parts request, then ask a suitably qualified independent Great Wall specialist which licensed technical information applies to the exact model and year.
- What Great Wall parts do UK breakers actually stock for the carburettor era?
- Request OE Great Wall 1982–1990 body panels, doors, tailgates and bumpers; the responding supplier must state source and condition. For engines, gearboxes and ECUs, ask for the donor details, test evidence, included components and written supplier terms. For service items mentioned in this era of manual, confirm whether the quoted item is OE-removed, remanufactured, new OE or aftermarket.
- Are these Great Wall vehicles ULEZ / CAZ compliant?
- Pre-OBD: faults read by analogue test lamp or factory break-out box, MOT emissions still done at idle only.